Why Not Customs has a complete line of Rockwell 2 ½ ton axles high steer arms. Our arms are Cad Engineered and then cut out of 1” thick steel by use of a water jet table. Our arms are built for the extreme off-road wheeler looking for strongest arms for their rig. All arms are drilled to the standard for 5/8” heim joints, but can be drilled to ¾” upon request. Our arms can be set up with counter sink taper for the studs for attachment to the knuckle. Don’t see what you want or need just ask as it can be built.
Standard Rockwell 2 ½ ton axle high steer arm / $125.00 each
- Drilled to 5/8” for drag link attachment
- Solid 1” thick full length of arm
6" to 8" lift High Steer Arm
Why Not Customs now has 6" to 8" lift high steer arms for the Rockwell 2.5 ton axles. Currently these are built to the customer requirements, so no product on the shelf. The standard lead time is 6 weeks. All of our arms are built out of 1" thick solid steel that is water jet cut. With our certified welder, the arms are then cut and built with the correct amount of lift and length from the center of the king pin that is needed to make your rig drive right. All arms can be order with tie rod tapered holes, or drill to 5/8, 3/4 ot 1" holes. Also you can have the 4 mounting bolts tapered for tapered cones that woud be used with studs.
Pictured below is our 6" lift high steer arm on customer trucks. Pictured is a Ford Super Duty and a Chevy mud race truck called Biggest Loser!
6" Lift High Steer Arms for Rockwell 2.5 ton axles / $325.00
8" Lift High Steer Arms for Rockwell 2.5 ton axles / $345.00
